Weider WECCSY9940 Manuel d'utilisateur télécharger pdf (Page 11)

20. Open the bag marked Pulley Bag 2 and remove one

“V”-Pulley (27). Keep the rest of the pulleys in the bag

for future identification.

Wrap the Butterfly Cable (73) around a “V”-Pulley

(27) in the direction shown. Attach the “V”-Pulley and

a Large Cable Trap (32) to the bracket on the back

of the Butterfly Upright (1) with a 3/8” x 2 1/2” Bolt

(53) and a 3/8” Nylon Locknut (50). Make sure the

Large Cable Trap is oriented as shown.

19. Locate and open the parts bag labeled “CABLE

ASSEMBLY.” For Cable identification and routing

during steps 19 to 49, refer to the Cable Diagrams

and Cable ID Chart on pages 23 and 24.

Identify the Butterfly Cable (73). It is approximately

52” long and it has a closed loop on each end. Attach

the Butterfly Cable to the bracket on the Left Butterfly

Arm (10) with a 3/8” x 1” Bolt (84) and two 3/8” Nylon

Jamnuts (63). Note: The loop on the Cable and the

two Nylon Jamnuts must be mounted underneath

the welded bracket.

18. Press a 1 3/4” Square Inner Cap (35) into each end

of the Right Butterfly Arm (11). Wet the lower end of

the Arm with soapy water. Slide a Butterfly Foam Pad

(29) onto the lower end of the Arm.

Lubricate the indicated axle on the Butterfly Top

Frame (33). Orient the Right Butterfly Arm (11) as

shown and slide it onto the axle. Secure the Butterfly

Arm with two Retainer Rings (31) and a 1” Round

Outer Cap (38). Note: Place the Retainer Rings on

top of the inverted Outer Cap and gently tap the

Cap onto the axle with a hammer. Make sure the

teeth on the Retainer Rings bend towards the Cap

as shown in the inset drawing.

Repeat this step to assemble the Left Butterfly Arm

(10, not shown).

Axle

Bracket

Teeth

Axle

Cable Assembly

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 34 35

Pas de commentaire

Weider WECCSY9940 Manuel d'utilisateur Page 11