Weider Pro 250 Bench Manuel d'utilisateur télécharger pdf (Page 4)

ASSEMBLY

Before beginning assembly, carefully read the

following information and instructions:

• Place all parts in a cleared area and remove the

packing materials; do not dispose of the packing

materials until assembly is completed.

• Read each assembly step before you begin.

• For help identifying the small parts used in

assembly, use the part identification chart

below. The number in parenthesis below each

part refers to the key number of the part. The

second number refers to the quantity needed for

assembly. Note: Some small parts may have

been pre-attached for shipping purposes. If a

part is not in the parts bag, check to see if it

has been pre-attached.

• Tighten all parts as you assemble them, unless

instructed to do otherwise.

• During assembly, make sure that all parts are ori-

ented as shown in the drawings.

THE FOLLOWING TOOLS (NOT INCLUDED) ARE

REQUIRED FOR ASSEMBLY:

• Two (2) adjustable wrenches

Assembly will be more convenient if you have the

following tools: A socket set, a set of open-end or

closed-end wrenches, or a set of ratchet wrenches.

M6 x 16mm Bolt (5)–2

3/4" Round Inner Cap (7)–4

38mm x 50mm Inner Cap (8)–1

38mm x 38mm Inner Cap (16)–1

M10 x 68mm Bolt (14)–1

M6 x 48mm Bolt (4)–2

50mm Round Outer Cap (9)–4

M10 Nylon Locknut (13)–1

1 2 3 4 5 6 7 8

Pas de commentaire

Weider Pro 250 Bench Manuel d'utilisateur Page 4