Weider WESY17011 Manuel d'utilisateur télécharger pdf (Page 11)

Bracket

17. Using an M10 x 80mm Bolt (25), an M10 Washer

(9), and an M10 Nylon Locknut (21), secure a

90mm Pulley (15) and a Cable Trap (66) to the

upper hole in the Press Frame (17). Make sure

that the Cable Trap and the Pulley are oriented

as shown.

18. Locate the Short Cable (23). Lay the Short

Cable inside the bracket on the Base (4). Attach a

90mm Pulley (15) inside the bracket with an M10

x 45mm Bolt (12) and an M10 Nylon Locknut

(21). Be sure that the ball on the Cable is on

the indicated side of the bracket.

Ball

19. Attach two 90mm Pulleys (15) and two Cable

Traps (66) to the Front Upright (42) with two M10

x 90mm Bolts (16), two M10 Washers (9), and

two M10 Nylon Locknuts (21). Be sure that all

parts are oriented as shown. Do not tighten

the Nylon Locknuts yet.

20. Route the Short Cable (23) around the 90mm

Pulley (15) attached to the lower hole in the Front

Upright (42). See the inset drawing. Be sure

that the Cable Trap (66) is turned to hold the

Cable in place and that the Cable is routed

around the Pulley as shown. Tighten the M10

Nylon Locknut (21) and the M10 x 90mm Bolt

(16).

Inset shows view

from other side

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 26 27

Pas de commentaire

Weider WESY17011 Manuel d'utilisateur Page 11