Weider WESY17011 Manuel d'utilisateur télécharger pdf (Page 8)

7. Lubricate both axles on the Top Frame (55). Slide

the Right Arm (48) onto the right axle. Note: Be

careful not to confuse the Right Arm with the

Left Arm (47); refer to step 6 to identify the

Right Arm. Be sure that the upper end of the

Right Arm is behind the indicated bracket on

the Top Frame.

Tap two 25mm Retainers (63) and a 25mm

Round Cover Cap (62) onto the right axle. Be

sure that the teeth on the Retainers bend

toward the Cover Cap, as shown in the inset

drawing.

Attach the Left Arm (47) in the same manner.

Press 45mm Square Inner Caps (44) into the

lower ends of the Right and Left Arms (47, 48).

Wet the lower end of each Arm with soapy water.

Slide a Large Foam Pad (45) onto the lower end

of each Arm.

Bracket

Lubricate

Axle

CABLE ASSEMBLY

Hook

Ball

8. During steps 9 through 22, refer to the CABLE

DIAGRAM on page 20 of this manual to verify

proper cable routing. Before beginning this sec-

tion, identify the Short Cable (23) and the Long

Cable (58) by comparing the lengths and the

ends of the cables.

IMPORTANT: While assembling the cables, do

not overtighten the bolts and nuts securing

the pulleys; the pulleys must turn freely.

9. Locate the Long Cable (58). Route the Long

Cable around a 90mm Pulley (15).

Using an M10 x 90mm Bolt (16) and an M10

Nylon Locknut (21), attach the 90mm Pulley (15)

to the Top Frame (55) in the indicated location. Be

sure that the end of the Cable with the ball is

on the indicated side of the Pulley and that

the Cable is between the Pulley and the hook

on the Top Frame.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 26 27

Pas de commentaire

Weider WESY17011 Manuel d'utilisateur Page 8