Weider 831.153930f Manuel d'utilisateur télécharger pdf (Page 19)

53. Wrap the Squat Cable (73) under a 3 1/2” Pulley

(78). Attach the Pulley and a Cable Trap to the sec-

ond set of holes from the top in the indicated brack-

et on the Long Base (120) with a 3/8” x 2” Bolt

(100) and a 3/8” Nylon Locknut (87). Make sure

that the Cable Trap is turned to hold the Cable

in the groove of the Pulley.

54. Wrap the Squat Cable (73) over a 4 1/2” Pulley

(119). Attach the Pulley to the indicated bracket on

the Top Frame (6) with a 3/8” x 1 3/4” Bolt (93) and

a 3/8” Nylon Locknut (87).

55. Place a 1/2” Washer (1) on top of the Weight Tube

(43) closest to the Squat Upright (4). Tighten a 1/2”

Nut (118) halfway onto the end of the Squat Cable

(73).

Lift the Weight Tube (43) and the Top Weight (45)

and make sure that the small pin on the Weight

Tube is inside of the groove under the Top Weight.

Hold the Weight Tube (43) and the Top Weight (45)

a few inches over the weight stack and insert the

Weight Pin (50). Screw the end of the Cable (73)

two full turns into the Weight Tube. Then, tighten the

Nut against the 1/2” Washer (1). Remove the Weight

Pin and set the Top Weight back on the weight

stack. Replace the Pin.

56. Locate and open the parts bag labeled “SEAT

ASSEMBLY.”

Insert the Pad Tube (23) into the square hole in the

Seat Upright (9). Slide the two Knee Pads (19) onto

the Pad Tube as shown. Press the two Knee Pad

Caps (109) into the ends of the Pad Tube.

Slide two Short Pads (20) onto the Leg Lever (10).

119

109

100

120

SEAT ASSEMBLY

118

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 34 35

Pas de commentaire

Weider 831.153930f Manuel d'utilisateur Page 19