Weider 15CT Manuel d'utilisateur télécharger pdf (Page 19)

TROUBLE-SHOOTING AND MAINTENANCE

Make sure all parts are properly tightened each time you use the weight system. Replace any worn parts immedi-

ately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.

TIGHTENING THE CABLES

Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is

slack in the cables before resistance is felt, the cables should be tightened.

Slack can be removed from the Short Cable (23) by

tightening the M8 Nylon Locknut (3) at the end of the

Cable.

Additional slack can be removed by moving the

90mm Pulley (15) to the lower hole in the Long “U”-

Bracket (57). Remove the Cable Trap (66) and the

Pulley from the “U”-Bracket. Re-attach the Pulley and

the Cable Trap to the lower hole in the “U”-Bracket

with the M10 Nylon Locknut (21) and the M10 x

45mm Bolt (12). Make sure that the Cable Trap is

in the proper position and that the Cable and

Pulley move smoothly.

Note: If a cable tends to slip off the pulleys, the

cable may have become twisted. Remove the

cable and re-install it. If a cable needs to be

replaced, see ORDERING REPLACEMENT PARTS

on the back cover of this manual.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26 27

Pas de commentaire

Weider 15CT Manuel d'utilisateur Page 19