Weider 15CT Manuel d'utilisateur télécharger pdf (Page 9)

10. Wrap the Long Cable (58) around a “V”-Pulley

(6). Attach the “V”-Pulley and a Long Cable Trap

(50) to the indicated bracket on the Front Upright

(42) with an M10 x 60mm Bolt (7) and an M10

Nylon Locknut (21). Be sure that the Long

Cable Trap is positioned to hold the Cable in

place.

11. Route the Long Cable (58) around a “V”-Pulley

(6). Attach the “V”-Pulley and a Long Cable Trap

(50) to the Left Arm (47) with an M10 x 60mm

Bolt (7) and an M10 Nylon Locknut (21). Be sure

that the Cable is in the groove of the Pulley

and that the Long Cable Trap is positioned to

hold the Cable in place.

12. Route the Long Cable (58) around a “V”-Pulley

(6). Attach the “V”-Pulley and the Long Cable

Trap (50) to the Right Arm (48) with an M10 x

60mm Bolt (7) and an M10 Nylon Locknut (21).

Be sure that the Cable is in the groove of the

“V”-Pulley and that a Long Cable Trap is

turned to hold the Cable in place.

13. Refer to the inset drawing. Using an M8 x

115mm Bolt (64) and an M8 Nylon Locknut (3),

attach the Pulley Bracket (20) to the indicated

bracket on the Top Frame (55). Note: The Pulley

Bracket is pre-assembled with a 90mm Pulley

(15) and a Cable Trap (66).

Route the Long Cable (58) around the 90mm

Pulley (15) attached to the Pulley Bracket (20).

Be sure that the Cable is in the groove of the

Pulley and that the Cable Trap (66) is turned

to hold the Cable in place. Make sure that the

M10 x 45mm Bolt (12), securing the Pulley and

Cable Trap to the Pulley Bracket, is properly tight-

ened and that the Pulley Bracket can pivot freely.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 26 27

Pas de commentaire

Weider 15CT Manuel d'utilisateur Page 9